Video at the construction site


Antenna assembly work topics video #7 (Drone 4K video Part4) (April 10th, 2019)

This is a drone video after the appearance of the antenna is completed.


Short video of the antenna assembly work long version (April 3rd, 2019)

This is a long version that summarizes the entire construction status of Misasa Deep Space Station.


Short video of the antenna assembly work ver.3 (March 6th, 2019)

This is a recorded video that summarizes the construction status in a short video. There are 3 volumes in all. Antenna sub-reflector / stay edition.


Short video of the antenna assembly work ver.2 (February 1st, 2019)

This is a recorded video that summarizes the construction status in a short video. There are 3 volumes in all. EL rotation structure part edition.


Antenna assembly work topics video #6 (Drone 4K video Part3) (December 4th, 2018)

It was taken with a drone with all the main reflector blocks attached.


Antenna assembly work topics video #5 (Night Sky Version) (November 27th, 2018)

It was taken with the starry sky in the background with all the main reflector blocks attached.


Antenna assembly work topics video (Drone 4K video Part2) (November 27th, 2018)

It was taken with a drone with 8 sets of main reflector blocks attached.


Antenna assembly work topics video #4 (Main reflector No.5, 9, 3 Lifting) (October 24th, 2018)

Lift the blocks No.5, No.9, and No.3 of the main reflector.


Antenna assembly work topics video (Drone 4K video Part1) (October 10th, 2018)

The antenna assembly work was shot with a drone on October 3, 2018. Please take a look at the magnificent appearance of the antenna as seen from the drone.


Antenna assembly work topics video #3 (Main reflector No.4 Lifting) (October 10th, 2018)

Lift the blocks No.4 of the main reflector. Can you see the wire pulling from the bottom right? This time it is an angle from the ground. It is editted at 100x speed. It also contains audio, but it is fast-forwarding, so it is a high-pitched noise. Please turn down the volume and browse.


Antenna assembly work topics video #2 (Azimuth rotaion) (October 10th, 2018)

This is an image of Az rotated 180 degrees to attach the main reflector panel (block 4). Since it is driven manually, it rotates more slowly than usual.


Antenna assembly work topics video #1 (Main reflector No.8 Lifting) (October 10th, 2018)

As the first video of construction topics, it is a recorded video of block No. 8 lifted on September 23.

  1. Detach from dummy centering and move to the specified position
  2. Attach the awning panel to the back
  3. Inclin about 30 degrees
  4. Lift and attach to center ring

* The resolution is reduced.


Antenna assembly work time-lapse video (Az Rotating structure part) (July 30th, 2018)

This is a time-lapse image of the fixed-point surveillance camera image as the Az rotation structure part.

Click here if you can't see. (470MB)


Short video of the antenna assembly work ver.1 (July 30th, 2018)

This is a recorded video that summarizes the construction status in a short video. There are 3 volumes in all. First is the Az rotating structure section.

Click here if you can't see. (213MB)


Antenna foundation work and power building work

This is a fast-forward video of the situation of foundation work (4 / 28-12 / 8) taken with a fixed-point surveillance camera. Fast forward processing at 200x speed.