| Daily Events on 2009/05/05 (Tue) | last updated at 2009/05/05 11:36:24 JST |
| Station |
Pass No. |
Contact time (UT) |
Max. Elev. |
Events |
|
|
AOS |
LOS |
||||
USC34 |
0100 |
07:31:39 |
07:43:03 |
15.2 |
OP/OG upload XRT: TI-CMD EIS: TI-CMD SOT: TI-CMD DR playback (by OP) |
MSP1 |
8010 |
08:02:10 |
08:13:59 |
18.0 |
OP/OG upload, XRT:TI-CMD, SOT:TI-CMD, EIS:TI-CMD (backup) AOCS: Upload pointing table AOCS: Upload orbital element EIS: Table upload |
USC20 |
0200 |
09:07:38 |
09:20:25 |
41.1 |
DR playback (by OP) SOT: table upload XRT: Table upload |
USC20 |
0400 |
21:09:25 |
21:22:59 |
70.8 |
DR playback (by OP) |
USC20 |
0500 |
22:49:08 |
22:56:15 |
8.5 |
DR playback (by OP) |
|
Flare list(LM) : http://www.lmsal.com/solarsoft/last_events/ DR information
daily note Co-alignment program run: Please run co-alignment program on May 6 for the three instruments. - The sequence should start exactly 15 minutes after the pointing change to stabilize the satellite pointing drift. - 100 minutes for N-limb at 945 arcsec and 100 minutes for E limb at -945 arcsec. - Not necessary to be during SAA-free time. - For XRT, take G-band data every 5 minutes instead of 8 minutes. This is just for the N limb run. 8 minutes cadence is still OK for the E limb run. - For XRT, please take data even during SAA periods AND TWILIGHT periods. SOT: RCO phone 1-650-644-6147, Tom Cruz local backup * HOP 117 (IBIS, Sac Peak), track a pore. * HOP 73 (Prominence ToO; Y. Lin & Berger) * support S-pole coronal hole study (SP, do before HOP 73) * SP flats at Sun center. EIS: * HOP 73 (Prominence ToO; Lin & Berger) * Coronal hole boundary reconnection (Murray) - minimum 6 hours on coronal hole boundary - FOV 70" x 200": request XRT and SOT to match with similar FOVs (within capabilities); - EIS takes slit images at 100-second cadence; equal to or better than this would be good from SOT and XRT. - support S-pole coronal hole study by XRT XRT: XRT RCO phone number: 1-617-496-1156 - HOP 117 support - HOP 73 prominence support - S-pole coronal hole study
|
|
operation files pointing file : none |